Hey Guys, we just wrapped up this Evo X. This car previously made 363 with a FP red and all the basic bolt ons back in March. This time around we added Kelford Stage 2 Cams, valve springs, headstuds, and an upgraded fuel pump. The gains were very impressive. 397.8 @ 28psi on our Dyno Dynamics on 93 oct! Dyno chart below. Enjoy! :)

Mod list:


2008 Mitsubishi Evolution X
- Cobb AccessPort
- FP Red
- DW 800cc
- Kelford Stage 2 Cams w/ valvesprings
- Walbro fuel pump
- AMS FMIC
- AMS Upper and lower IC piping
- AMS MBC
- Full exhaust with ams dp & testpipe
- AMS intake
- AMS fuel rail

http://onfinite.com/libraries/1610337/bb2.jpg

http://onfinite.com/libraries/1610338/98d.jpg

http://onfinite.com/libraries/1610341/dd0.jpg

Any chance you can overlay the old plot with the new?

I'll see if I can overlay it tomorrow :) I'll have to pull the old plot from the dyno.

Nice numbers guys.

nice work

I am surprised you did not run out of 800cc injectors...

ya, arnt those 800cc injectors holding back power? I thought 800's could hold back a green in many cases, so, having a red w/ cams, is almost definately a limiting factor?

I run 1100's just fine with E-85 and a Red.

The 800's with pump 93 should be just fine. 800 * 1.30 = 1040.

Both are close to being maxed out, but not quite.
(I'd recommend higher if these are the mods you are shooting for, but sometimes you have to work with what you have.)

strong number on a dyno dynamics. What gs are you pushing on the turbo and your idc has to be at the max.

Any chance you can overlay the old plot with the new?

+1

Nice graph though.

I used 1000cc injectors for E85 with my Red and cams at 33psi...granted I had a double pumper...but the 800cc's seem to be possible to do this in my book.

That is some mean AccessPORT Power!!!

Hell yeah forged! They did my tune - still runs perfect! That is some crazy power considering how their Dyno Dynamics dyno reads :D Well done Sharif, Ryan & Co!

Thanks for the nice words guys :)

I ran out of 800cc injectors at 7100 rpm with the Green @ 27 psi and base pressure of 50 psi with 696 Scaling.

Rocking the FIC 1100cc now... :)

Hell yeah forged! They did my tune - still runs perfect! That is some crazy power considering how their Dyno Dynamics dyno reads :D Well done Sharif, Ryan & Co!


what mods did u have when you got tuned? what did you put down?

That is some mean AccessPORT Power!!!

Thank you Mr. Cobb. We are proud to be one of the most active Cobb Pro Tuners in the country. We can't do this without you guys! :)

what mods did u have when you got tuned? what did you put down?

Current mods. I put down 303 in 4th gear pull.