http://www.metacafe.com/watch/501379/remove_car_dent_with_airduster/

Wonder if it works with smaller dents.

That is very cool. If I am unfortunate enough to need to try this (I've been lucky the last few years with newer cars) I will give this a go.

I may give this a go on my truck.

do u guys think this will work on plastic parts?

do u guys think this will work on plastic parts?

Probable not. The blow dryer might warp the plastic.

do u guys think this will work on plastic parts?

I agree with Chris and suggest it may not work. However, if you are willing I would like to see you do some experiments. Try it with just the CO2. Is it a big dent, which part is it in?

i got nicked by another car at a parking lot never knew who it was.grrrrrr
i will try this but i dont think it'll pop out looks too small and tight.

if it's small and tight.. and in plastic, I really doubt it'll work sadly.

one of my roommates has a camry with a very broad dent in the front fender, we're going to give it a try and I'll be sure to take video when that eventually happens :)

no mine its in the rear driver side next to the gas door.and it metal or whatever but a magnet sticks so its metal.

I figure it'll work on dents that "the ding king" works on :P

i may give this a try hope it works cause its really anoying seen that dent on my car and dont have the time or money right now for a shop repair.i got the black paint off from the other car with a gas damp rag.

Anyone actually try this yet?

No dents on my car yet......I hope :)