Cam install with timing chain - Page 2 - EvoXForums.com

mantella · 09-04-2012, 11:31 PM

i have had ones that where very close to stock and swapping buckets around took care of it but then my kelford 214a cams i had to replace alot of the buckets.

palmerblock · 09-05-2012, 05:25 PM

did you hit it dead on first try on the swap? the buckets that is...

Quote:

Originally Posted by mantella

i have had ones that where very close to stock and swapping buckets around took care of it but then my kelford 214a cams i had to replace alot of the buckets.

mantella · 09-14-2012, 06:24 AM

I just saw this. no it took a couple tries but no biggie and i have a pretty large assortment of them so no wait time for me. the tomei 270 cams i am currently using was a lot easier and could use stock buckets just by switching them around a bit.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cam removal without taking off timing chain cover?	saytheb	Evo X Engine (4B11T)	20	07-19-2012 11:10 PM
Aftermarket timing chain?	irmerm	Evo X Engine (4B11T)	12	12-29-2011 04:43 PM
Timing Chain Warning	08gsr-sss	Evo X General	3	08-18-2010 12:43 PM
Elongated Timing Chain	markymarc	Evo X Engine (4B11T)	22	08-29-2009 04:04 AM

09-04-2012, 11:31 PM	#11
mantella X-phile Join Date: Mar 2009 iTrader: (100) Location: louisville Posts: 747	i have had ones that where very close to stock and swapping buckets around took care of it but then my kelford 214a cams i had to replace alot of the buckets.

09-14-2012, 06:24 AM	#13
mantella X-phile Join Date: Mar 2009 iTrader: (100) Location: louisville Posts: 747	I just saw this. no it took a couple tries but no biggie and i have a pretty large assortment of them so no wait time for me. the tomei 270 cams i am currently using was a lot easier and could use stock buckets just by switching them around a bit.

Remove Advertisements Sponsored Links
Evo X Forums Advertisement