|Today 03:19 AM|
Finally got these installed:
Girodisc Front and Rear Slotted 2pc Rotors
Girodisc S/S Front and Rear Brake Pads
AMS Stainless Steel Brake Lines
Also picked up new shoes, Michelin Pilot Sport 4S
|06-30-2019 10:53 PM|
Installed @ClubSpec NRG OPS MIVEC Extension Harness, ClubSpec Master Cylinder Brace and @Chasing Js Titanium coil pack cover.
|06-20-2019 03:07 PM|
|AiZ||So I haven't really figured out what the MIVEC extender actually accomplishes there - is it just so you can use the OEM engine harness while still tucking away the coil pack wires? Or is it just to make the wire tuck process easier, but still requires chopping up the harness?|
|06-20-2019 02:42 PM|
Picked up @ClubSpec NRG Ops MIVEC Extender (Wire Tuck PnP) & ClubSpec Master Cylinder Brace.
|06-13-2019 04:07 AM|
Picked up ETS V3 Extreme Exhaust and MAP Recirc DP.
Will send out DP for Ceramic Coating in the coming weeks.
|06-05-2019 02:37 PM|
Yes, that applies to any rotors and pads if you don't break them in properly. I plan to break in the pads and rotors according to the bed-in procedures.
No more dead batteries. Picked up a NOCO G7200 UltraSafe Battery Charger and Maintainer.
|05-31-2019 05:46 AM|
|MR. EVO MR||
I was very disappointed when my slots faded on my girodisc two piece rotors so I upgraded to the stoptech aero drilled rotors.
Anyways make sure you bed them in correctly to get the best stopping.
|05-30-2019 04:44 AM|
OEM battery was shot.
Replaced it with this.
With vent tube port.
|05-27-2019 07:31 PM|
Just got home from vacation and had a surprise in the mail.
Most likely install next month.
|05-18-2019 10:06 PM|
|KTMrider||Never saw a shorty antenna that was so short. What brand and how is the reception?|
|This thread has more than 10 replies. Click here to review the whole thread.|