Mitsubishi Lancer Evolution Forum banner

Evo x to evo 8 diff swap

1K views 1 reply 2 participants last post by  turismolover22 
#1 ·
So I've completed the swap and used a evo 8 rear diff with DSS axles for the conversion. QUESTION- do any of you guys that completed the swap and have the DSS axels have any play with the axles from the shaft moving in and out of the diff holes on both sides? Like I legit can pull my axles out about a 1/2 to 3/4s of an inch. Keep in mind that this happens with the axle nut still in place and torqued down. My car makes like a certain clicking noise when taking off in first gear (not launching). Thank you guys in advance.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top