Mitsubishi Lancer Evolution Forum banner

New Engine P0013 HELP!!!!!!

4K views 4 replies 3 participants last post by  smash493 
#1 ·
Just installed a fresh built 2.2 Buschur stroker. Start the car and p0013 pops up, "B" Camshaft Position Actuator Circuit (Bank 1), wiring from connector to ecu is good, relay is good, valve is good. I just want to drive this thing! Does anybody have an ideas on what could cause this or where to look?? Being a circuit code, I wouldn't think it would have to do with anything internal but correct me if I'm wrong. Any help is appreciated!
 
#4 ·
Did you install cams and or valve springs? I’ve heard of people having their Mivec housings crack and leak. Mivec won’t engage though, so it would be obvious around 5000 RPMs. I also have a Buschur stroker. The engine has been solid, but the tuning wasn’t very good. I had to pay a small fortune to CBRD to straighten out everything. Picked up a shit load of spool and torque compared to Buschur’s tune.
They also built my head and installed cams, haven’t had any trouble there.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top