Mitsubishi Lancer Evolution Forum banner
1 - 20 of 28 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 · (Edited)
Just got my car tuned at carz performance today in lakewood colorado and here are the results tell me what you think. 315awhp 309awtq. Superflow dyno
 

Attachments

·
Registered
Joined
·
25 Posts
Discussion Starter · #5 ·
Everything is bone stock except for hks intake and ets test pipe
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #7 ·
Feels amazing consistant power through out the power band. Very pleased with the result.
 

·
Registered
Joined
·
8,771 Posts
You should have hooked up with the other guy here today getting over 400tq on bolt-ons and 93, you could have at least had a dyno sheet reading over 350tq, maybe even on 87 octane. :thumbup:
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #12 ·
Im on 91 pump gas my car is bone stock except for intake and test pipe. They did not adjust the boost at all and is a very reliable tune. Which shop are you refering too. Btw this dyno is one of the lowest reading dyno's in CO.
 

·
Registered
Joined
·
127 Posts
That kinda power in Colorado? What's elevation are you at?
 

·
Registered
Joined
·
10,007 Posts
congrats, great numbers for minimal mods, great baseline too.
 

·
[Local Team Member], aka pimplay2
Joined
·
7,791 Posts
You should have hooked up with the other guy here today getting over 400tq on bolt-ons and 93, you could have at least had a dyno sheet reading over 350tq, maybe even on 87 octane. :thumbup:
yea I was about to say that also, but if you check the dyno sheet, his boost is around 22
 

·
Registered
Joined
·
1,161 Posts
Not bad for a few bolt ons an untouched boost
 

·
Registered
Joined
·
1,038 Posts
His baseline seems right. I baselined my X and had 264/282 on a dynojet
 

·
[E-Tuner]
Joined
·
15,922 Posts
Im on 91 pump gas my car is bone stock except for intake and test pipe. They did not adjust the boost at all and is a very reliable tune. Which shop are you refering too. Btw this dyno is one of the lowest reading dyno's in CO.
Just cause boost wasn't touched, doesn't mean its very reliable. ;)
 
1 - 20 of 28 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top