Mitsubishi Lancer Evolution Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter #1
I was wondering if anyone has done this? i just ordered an AMS intake w/o the bungs and i ordered the bungs from AMS, So has anyone done this custom install if so what drill bit did you use to install?
 

·
aka mrubino83
Joined
·
4,161 Posts
I kind of did. I took out the grommets on the intake and just welded the nipples on there. Same thing.
 

·
Registered
Joined
·
64 Posts
Discussion Starter #6
There were already pre-existing holes where the grommets went in. If they werent there then I would have drilled, then welded.
oh really? i asked the guy from AMS he said there were no pre-exisiting holes.. thats why i started this thread
 

·
Registered
Joined
·
706 Posts
id get the order change to one with the bung or buy a caugh can and tune it out. dont suggest drilling and adding bung if there is leak it will cause idle issues and loss of boost.
 
1 - 8 of 8 Posts
Top