Mitsubishi Lancer Evolution Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
55 Posts
Discussion Starter · #1 ·
Hoping someone can help, I've installed an Ethanol sensor on my Evo X, the output needs to go to pin 112 on the ECU to work with Tephra V3.

Being an AU MY14, this pin is unpopulated on my harness (as they are with all AU models) and isn't as simple as plugging in to the fuel vent wiring under the rear seat.

Can anyone tell me what type of terminals are used on the Mitsubishi ECU? I've googled and searched and reach out to a few people with no definitive answer.

Looks like it isn't going to be much fun installing the terminal.

Any help would be greatly appreciated.

Cheers,

Simon
 

· Registered
Joined
·
550 Posts
Reach out to OHM Racing and see if they can tell you. It looks like the harness they build requires the factory core (they'll sell you ECU connectors for a 8/9) so it may not be available outside of buying the harness from Mistu. They will be able to source you the right pins if that's all you need.
 
1 - 2 of 2 Posts
Top