Mitsubishi Lancer Evolution Forum banner

FS [NJ]: Skene Design License Plate Bracket

1913 Views 5 Replies 4 Participants Last post by  B Home 916
This is a great solution for those who don't want to drill their front bumper. Selling because I prefer the look of the OEM bracket. The bracket is new and only taken out of the box to check fitment.

$40 shipped


New
http://www.skenedesign.com/FPBracket/index.shtml
See less See more
1 - 6 of 6 Posts
Why didn't you like the look of it, just curious? Was something off?

Did you get the short size as the website recommends?
Why didn't you like the look of it, just curious? Was something off?

Did you get the short size as the website recommends?
The license plate looks like it was floating when viewed from the side. It looked a bit too aftermarket for my taste. I'm keeping my Evo 100% stock & I actually like the look of the side bracket (pity you have to drill the bumper).

Yes it's the short size.
Any pics on the car?
I have it on my car. Well, had... the self-taping screws used to mount it dont hold up to a power washer, so plan on replacing them with a nut/bolt setup. I've been lazy :D Other than that, I think it looks fine.
I'll take the mount, sent you a PM Ketchup

Majik, do you have a picture laying around of your mount?
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top