Mitsubishi Lancer Evolution Forum banner

How do I bend an exhaust bracket?

830 Views 5 Replies 6 Participants Last post by  churbo
I need to bend one of my exhaust brackets because my ets exhaust is rattleing against it. It's not touching very much, but enough that it sounds bad.

Can I use a wood block and hammer or do I need to heat it with a welder and bend it?

I only need to move it a 1/4 or 1/2 inch at most.
1 - 6 of 6 Posts
Post a pic of the bracket and I'll try and help you out.
sorry friend read the post its confusing to me i mean your post in not clear to me can i have more stuff.
Put the box end of a big wrench on the hanger and bend. If it's to thick you may have to heat it up.
Rubber hammer would do it. As long as you aren't bending it too much or going one way then back the other a few times then you won't have to worry about it breaking.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top