Mitsubishi Lancer Evolution Forum banner
1 - 6 of 6 Posts

·
Premium Member
Joined
·
21,476 Posts
That's how I did it. Regular stapler (not even a red swingline!). I didn't even open it, I just stapled it like it was a piece of paper.

Your staples might go through the plastic to the other side a little (I got maybe 1/4mm sticking out on maybe 4 staples). If that happens, on the inside edge of the staple just use a small screwdriver to back it out that 1/4mm until the staple isn't poking through anymore. It still holds perfectly.

And the whole time you have to quote office space "That's my stapler..."
 

·
Premium Member
Joined
·
21,476 Posts
Huh? My staples went right through the plastic. It's not hard plastic. That's how they fasten the armrest cover to the armrest plastic.

My staples stayed straight. They were short enough that they didn't go all the way through the plastic (in most cases), reach the other side of the stapler and "curl" around like they do with paper.

Make sense?
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top