Mitsubishi Lancer Evolution Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Could anyone give me a hand with configuring evoscan to log a Motec PLM.
The PLM uses serial
Byte Description Value
0 Header 0 = 0x80 0x80
1 Header 1 = 0x81 0x81
2 Header 2 = 0x82 0x82
3 Data Length 32
4:5 PLM 1 (Master) Calibrated sensor reading Hi:Lo = x.xxxLa
6:7 PLM 2 Calibrated sensor reading Hi:Lo = x.xxxLa
8:9 PLM 3 Calibrated sensor reading Hi:Lo = x.xxxLa
. .
. .
32:33 PLM 15 Calibrated sensor reading Hi:Lo = x.xxxLa
34:35 PLM 16 Calibrated sensor reading Hi:Lo = x.xxxLa
36:37 Checksum Hi:Lo = 16 bit sum
of unsigned bytes 0
to 35

Any help would be appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top