Mitsubishi Lancer Evolution Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter #1
hi, i have my innovate LC1 module installed that link the display to Blitz icolor BC, sometimes it works find and show me correct reading, sometimes it just display 7.35~7.48 even if i Restart the engine, it just display 7.35, and out of 10 time i use my car, it only work properly for 2 times, means 80% of time i just display the wrong no.

I have written to Innovate for 2 months i never got their reply...

HELP.
 

·
Registered
Joined
·
56 Posts
Discussion Starter #3
hi all, what i have seen now on my innovate is that, when i just switch it on, it shows 7.35 and after 10seconds, it shows correct a/f for 2 second then it change back to 7.35 again till forever.

Innovate has replied me saying it is the fault of the sensor, so i am not sure whether the bosch sensor's life span is really that short? What is the best sensor which is much reliable in the market other than Bosch, i think i need to find one if innovate doesn't cover the warranty.
 
1 - 3 of 3 Posts
Top