Hey guys, been searching everywhere and can't find any good instructions. Purchased the Varis rear bumper and ran into a snag during install.
Hopefully someone with install experience can chime in. It seems as though the bracket that houses the license plate bulbs is not even close to being able to fit through the slot in the new bumper. In the instructions, this bracket doesn't even exist, at least in the pictures.
Being that this bracket is welded onto the bumper, do I have to angle grind it off? Anyone have a good solution for this? I'll grab some pictures as well if I'm not making sense.
Thanks everyone
Hopefully someone with install experience can chime in. It seems as though the bracket that houses the license plate bulbs is not even close to being able to fit through the slot in the new bumper. In the instructions, this bracket doesn't even exist, at least in the pictures.
Being that this bracket is welded onto the bumper, do I have to angle grind it off? Anyone have a good solution for this? I'll grab some pictures as well if I'm not making sense.
Thanks everyone
